901.18 Laboratory Testing for Sec 901

From Engineering_Policy_Guide
Revision as of 12:28, 30 March 2010 by Smithk (talk | contribs) (→‎901.18.1 Procedure: minor clarification)
Jump to navigation Jump to search

This article establishes procedures for testing and reporting Laboratory samples of bolts, nuts, washers and polyurethane foam used in highway lighting. Refer to Sec 901 for MoDOT’s specifications.


901.18.1 Procedure

Bolts, Nuts, and Washers

Chemical tests consisting of mass of coating, shall be determined according to AASHTO M232. Original test data and calculations shall be recorded in Laboratory workbooks. Test results shall then be recorded through SiteManager.

Physical tests shall be conducted according to EPG 712.3.2.2 Physical Tests - Bolts and Nuts. Test results and calculations shall be recorded through SiteManager.

Polyurethane Foam

Tests on samples of polyurethane foam shall be conducted in accordance with the following methods:

(a) Compressive Strength - ASTM D1621
(b) Density - ASTM D1622

Test results and calculations shall be recorded through SiteManager.

901.18.2 Sample Record

The sample record shall be completed in SiteManager, as described in Automation Section 3510, and shall indicate acceptance, qualified acceptance or rejection. Appropriate remarks, as described in Reporting Test Results, are to be included in the report to clarify conditions of acceptance or rejection. Test results shall be reported on the appropriate templates under the Tests tab.

Retrieved from "https://epgtest3.modot.org/index.php?title=901.18_Laboratory_Testing_for_Sec_901&oldid=22391"