Category:1009 Aggregate for Drainage
This guidance establishes procedures for the inspection and acceptance of aggregate for drainage.
1009.1 Procedure
Inspection, testing, and sampling will be governed by the instructions contained in General Requirements for Material.
| TEST | Template | Template Description |
|---|---|---|
| Sieve Analysis | T27 | Sieve Analysis of Fine and Coarse Aggregate |
| Percent Deleterious | SAA001Hx* | NEWEST Deleterious 1009 Aggregate |
| *Test Template numbers have been depicted with a generic ‘x’ as some templates are updated and the last letter in the template name may change. The most current template for a template sequence should contain ‘NEWEST’ at the beginning of the template name. | ||
Samples required for Laboratory tests are as follows:
- (a) Initial Evaluation.
- (b) Source Approval. Must meet 1002 quality as required in General Requirements for Material - Source Approval.
1009.2 Acceptance
Acceptance is based on routine tests in the field to ensure compliance with the requirements of Sec 1009. Samples are to be taken at destination or at the source of aggregate production by MoDOT inspectors at intervals of one per 1,500 tons.
1009.3 Records and Reports
All plant records shown in General Requirements for Material - Records and Reports shall be maintained. The material shall be reported through SiteManager in accordance with Automation Section AS-3510.