905.2 Traffic Studies: Difference between revisions

From Engineering_Policy_Guide
Jump to navigation Jump to search
Smithk (talk | contribs)
m minor clarifications
Smithk (talk | contribs)
Line 66: Line 66:
===905.2.9 Traffic Control in School Areas===
===905.2.9 Traffic Control in School Areas===


When reviewing traffic control in school areas, refer to [[902.4 Installation of Equipment by Others|EPG 902.4 Installation of Equipment by Others]].  Another source of information involving traffic and pedestrian operations in school areas is the manual [http://www.safetycenter.cmsu.edu/publications/schooltransportation.html ''School Transportation & Traffic Safety – Guidebook for Local Agencies''] that was published for local agencies in 1996 using TTAP funds.  Any information from the guidebook is secondary to the EPG.
When reviewing traffic control in school areas, refer to [[902.11 Traffic Control for Schools|EPG 902.11 Traffic Control for Schools]].  Another source of information involving traffic and pedestrian operations in school areas is the manual [http://www.safetycenter.cmsu.edu/publications/schooltransportation.html ''School Transportation & Traffic Safety – Guidebook for Local Agencies''] that was published for local agencies in 1996 using TTAP funds.  Any information from the guidebook is secondary to the EPG.


===905.2.10 Pedestrian and Bicycle Facilities===
===905.2.10 Pedestrian and Bicycle Facilities===

Revision as of 08:54, 19 January 2012

905.2.1 Highway Capacity Analysis

According to the Highway Capacity Manual 2000, the capacity of a facility is the maximum hourly rate that persons or vehicles can reasonably be expected to traverse a point or uniform section of a lane or roadway during a given time period under prevailing roadway, traffic and control conditions. The HCM 2000 provides methodologies for calculating capacity for

  • urban streets
  • signalized intersections
  • unsignalized intersections
  • pedestrians
  • bicycles
  • two-lane highways
  • multilane highways
  • freeway facilities
  • basic freeway segments
  • freeway weaving
  • ramps and ramp junctions
  • interchange ramp terminals and
  • transit.

TMS has also developed a highway capacity analysis tool.

905.2.2 Crash Analysis

A crash analysis is performed for a traffic study to determine whether a safety or operational problem exists. Crash information is obtained during the data collection phase of the traffic study. Crashes are reviewed for severity level of crashes as well as total number of crashes. A high number of crashes having no severe crashes typically indicates a location with high traffic volumes and a potential capacity or operational issue. A location with severe crashes should be reviewed for sight distance, signing, signal timing or other roadway features that may be leading to improper driver behavior. When performing a crash analysis, look for crash patterns that may lead to easily recognizable countermeasures. A collision diagram helps to identify crash patterns.

When calculating crash rates during the analysis, compare the calculated rate to the statewide rate. Typically non-intersection studies are compared by roadway type. Comparisons by roadway type are a better indication of a roadway’s safety than comparisons by route designation. For instance, a rural county lettered route functions differently from Rte. D (Page Ave.) in St. Louis County. It is also important to compare routes by urban/rural classifications. For most routes, a crash rate is considered poor when it starts to reach double the statewide average.

905.2.3 Countermeasure Selection

The selection of countermeasures is covered in the HAL Manual and NCHRP 500 series. Both of these documents should be used as reference tools only. Any information contained in these documents is considered secondary to the EPG. Both of these guides start with identified problems and use charts to match potential solutions to the identified problems. These charts are comprehensive but are not the only solutions possible. At the national level, there is a project underway to develop a highway safety manual. Much like the HAL Manual and NCHRP 500 series, the Highway Safety Manual will feature a chart of known problems with potential solutions to those problems.

905.2.4 Human Factors of Roadway Safety

Human factors should be considered when conducting a traffic study. Keep in mind the following factors of the traveler:

  • Age, that is the needs of older or younger drivers
  • Cone of vision
  • Placement of traffic control devices
  • Legibility, especially the size and font of lettering
  • Perception-reaction time
  • Driver overload, that is, concentrating too much information for a driver to reasonably accommodate
  • The number of lines of legend
  • Advance placement of signing/delineation
  • Sign spacing
  • Effect of colors
  • Device visibility and
  • Driver expectations.

905.2.5 Highway Signing

When reviewing highway signing, refer to EPG 903 Highway Signing.

905.2.6 Temporary Traffic Control Devices

When reviewing temporary traffic control devices, refer to EPG 616 Temporary Traffic Control.

905.2.7 Pavement Marking

When reviewing pavement marking, refer to EPG 620 Pavement Marking.

905.2.8 Traffic Signals

When reviewing traffic signals, refer to EPG 902 Signals.

905.2.9 Traffic Control in School Areas

When reviewing traffic control in school areas, refer to EPG 902.11 Traffic Control for Schools. Another source of information involving traffic and pedestrian operations in school areas is the manual School Transportation & Traffic Safety – Guidebook for Local Agencies that was published for local agencies in 1996 using TTAP funds. Any information from the guidebook is secondary to the EPG.

905.2.10 Pedestrian and Bicycle Facilities

Pedestrian and bicycle facilities should be considered on every project. When reviewing pedestrian facilities, refer to EPG 642 Pedestrian Facilities and EPG 641 Bicycle Facilities when reviewing bicycle use and facilities.

905.2.11 Law Enforcement

Law enforcement at a location can reduce the number and severity of crashes, provide orderly flow of traffic and detect offenders of traffic violations. When considering law enforcement as a countermeasure, several options are available including contacting Highway Safety or the regional Blueprint representative, the local law enforcement agency direct or consider automated enforcement options. Crashes that do not have a direct engineering solution should not be disregarded. Highway Safety provides law enforcement agencies contracts to enforce hazardous moving violations and driving under the influence of alcohol violations. Law enforcement should also be considered for work zones. Refer to EPG 616.16 Law Enforcement Services when considering law enforcement in work zones.

905.2.12 Traffic Calming

When drivers are not behaving as intended on a route, traffic calming solutions should be considered. The Traffic Safety Toolbox, ITE publication, 1999 edition states, “Traffic calming is the combination of mainly physical measures that reduce the negative impacts of motor vehicle use, alter driver behavior and improve conditions for non-motorized street users.” Techniques to consider for traffic calming include:

  • road closures and diverters
  • horizontal deflections and
  • vertical deflections.

Other considerations when reviewing options for traffic calming include

  • maintenance
  • public perception
  • emergency response
  • spacing of calming devices
  • residents’ mobility
  • effects to pedestrians/bicyclists
  • relocation of problems
  • noise
  • accident rates and
  • enforcement.